PS-24V2 24Volt Universal Power Supply
A 24 volt, switching power supply with universal input. Although intended for use with Radio Design Labs products, it may also be used wherever a convenient source of DC power is required. A range of mounting accessories are available.
Built in a plastic case, the supply has a captive output lead fitted with a co-axial connector which will interface directly with many RDL modules. This is a ground-referenced power supply. AC supply is by IEC inlet. It has short-circuit, over-current and overload protection. Output: 24V DC at 2.0A. Line regulation: 1% maximum. Load regulation: 5% maximum. Ripple and noise: 1% p-p maximum. Temperature: 0 to 40°C, ambient, at full load. Power source: 100 to 240 volts AC, 50/60 Hz, 1.11A (115V AC); 0.49A (230V AC). Dimensions: 120 x 50 x 34 (l x w x h) mm.
PS-24AX 24 Volt Universal Power Supply - 500mA
This is also a switching power supply, but in plug-top format. It has interchangeable plug contacts for the AC input and a captive power lead with coaxial connector for the DC output, compatible with many RDL modules.
Power source:100-240V AC. Output: 24V DC, 500mA. Dimensions: 46mm x 70mm x 35mm nominal. Efficiency: Energy Star level IV
PS-24KX 24 Volt Universal Power Supply - 1Amp
Similar to the PS-24AX, this is slightly larger, and has increased output capacity
Power Source: 100-240V AC. Output: 24V DC, 1A. Dimensions: 46mm x 93mm x 36mm nominal. Efficiency: Energy Star level V.
Optional accessories: FP-PSB1A Power Supply Mounting Bracket mounts an RDL PS-24V2 power supply to any flat surface or in an RDL Flat-Pak series rackmount panel with a FP-PA20 audio power amplifier mounted directly to the FP-PSB1A. Also includes a provision to mount 4 STICK-ON modules by adding the ST-PBR4 (See RDL STICK-ON Mounting Accessories for further information). RC-PS5 power supply tray is a 1U rack-mounting tray which will mount up to five PS-24V2 supplies. RU-PSB1 mounting kit will accept one PS-24V2 supply and two RDL Stick-On modules such as ST-PD5U power distribution modules, and has a cover. This in turn will mount in RDL hardware intended for Max Rack-Up modules, providing a convenient means of powering a rack-mounted set of RDL modules. DRA-35P mounts a single PS-24V2 supply to a flat surface or 35mm ‘top-hat’ DIN rail.