This range of plastic, surface-mounting back boxes is suitable for a wide range of applications. Manufactured from ABS, they are much less brittle than traditional electrical back boxes and so less…
A range of IDC connection modules that are fully compatible with Krone LSA-Plus and other similar designs. All modules use the same flame-retardant moulded housing, but a range of thicknesses of…
Stainless steel frames suitable for all 237 and ABS modules. Mounting frames 8A For 19" rack mounting, frames 8A offer either surface or recessed termination of up to 150 pairs (90 ABS circuits) and…
Ready-made connection boxes offering a range of low-profile to high-density termination of cables in plastic housings with all the cable-anchoring and cable-entry requirements catered for. Larger…
Inserter tool 2AAll termination of wires on TUK, Krone and similar connection blocks must be carried out using a special tool. The tool applies the correct pressure to both wire and contact and trims…
Unshielded RJ45 patch panels with performance exceeding Category 5E requirements. Rear IDC terminations present vertically or horizontally ('right-angle' version) and are compatible with Paladin, TUK…
Unscreened RJ45 patch panels with performance to Category 6 requirements ('component level').Rear IDC terminations present vertically and are compatible with TUK and Krone tools (as well as 110 type…
A ratchet type tool for crimping RJ45 type connectors. Two die sets are available, one is for Cat5E type plugs, the other suits Cat5E and Cat6 plugs. The tool is supplied without die sets, which…
Voice-over-IP enabled headsets, supplied terminated with USB plug, for direct connection to all computers with USB2.0 interfaces, and which require no driver or sound card.Available as monaural…
Please select from the list of categories above