EMO POWER DISTRIBUTION SYSTEM
A range of power distribution panels for 19” rack mounting. Suitable for both fixed and mobile installations. The system allows all rack mounted equipment to be fitted with a standard BS1363 13A, IEC 10 amp type E or Schuko connector, so that installation and removal of equipment is easy and safe. The availability of front mounted sockets allows standard connectors also to be used on portable external equipment. In installations where a large number of outlets are required, the initial unit can supply power to slave units through the outlets on its rear panel. If a detachable power input lead is required, see EMO POWER DISTRIBUTION PANELS. IEC jumper cables also available – see index.
All models have two neon indicators, the first wired to show the presence of supply input and the second to show failure status of the front-panel 13A fuse, located after the supply input.
NOTE: This range has been replaced with updated versions - see EMO POWER DISTRIBUTION PANELS.
||Shuttered 13A 3-pin to BS1363, Schuko 16A to CEE7/7 or IEC 6A to IEC 60320 type F.
||2m 1.25mm² 3 core flex.
||13A (all versions)
||483mm (19”) × 89mm (2u) × 85mm.
Note: 3 pin 13 amp connectors are approved for use in the UK and certain non-European countries only.
‘EMO’ is a registered trademark of Canford Audio Limited.