Dante enabled press splitters are used to avoid the unsightly clutter that results at events such as press conferences, when every broadcasting organisation present tries to erect a microphone directly in front of the speaker, precisely where the cameramen would rather they did not. The splitter takes a small number of inputs from microphones or the local mixer and distributes the signal to a large number of outputs for use by the media. AudioPressBox offer a comprehensive range of active and passive types in stage box, floor-box, desktop, rack and wall mounting formats as well as portable, cased, splitters and kits.
For a very limited number of broadcasters and journalists it may be possible to provide a set of outputs using multiple microphone splitters. However, this technique quickly increases the load on a microphone to the point where the signal quality is affected. A dedicated conference splitter will reduce clutter, be more reliable and prevent inter-action between the connections made by the different members of the media. Alternative terms for press splitter include 'conference splitter', 'presidential bridge', 'press box', 'multi box' and 'press distribution amplifier'.
Active splitters - Dante enabled
These Dante enabled splitters operate in much the same way as see AUDIOPRESSBOX CONFERENCE SPLITTERS – Active, however they have the capability of Dante audio input signals on RJ45 connection as the main input source.
APB-Dante products are PoE enabled whereby the power required (less than 2W for PoE) can be provided through the Ethernet cable from a PoE-capable network switch or compatible equipment. APB-112 IW-D includes a plastic in-wall installation box for flush finish. APB-112 OW-D is an on-wall splitter, and APB-112 SB-D is a portable press splitter.
APB-D116 R-D and APB-D216 R-D can be used as a drive unit for APB-008 SB-EX, APB-008 IW-EX, APB-008 OW-EX, APB-008 FB-EX, APB-024 R-EX, APB-P008 OW-EX, APB-P008 IW-EX, APB-P112 SB-EX.
APB-216 C-D is a portable pressbox with two analogue inputs plus a single input channel by way of Dante. The Dante input requires PoE.
|Note: 3-pin XLR connections are balanced.
The RC 3.5 -1 cable is intended for use between the mic or mic/line outputs of the splitters and expander units and recording equipment with 3.5mm jack inputs, microphone or line level, regardless of the stereo or mono configuration. The 3-pin female XLR contains electronic circuitry to provide level and impedance matching and DC blocking. The cable is 1.5m long.
The RC 3.5 - 8 is an eight-way cable which provides eight channels of the same functionality and is 3 metres long. It consists of an eight pair multipair cable, broken out into eight tails at each end.