Heavy duty cable crossovers for use across roadways and walkways, open venues, in fact anywhere that cables are left exposed in hostile environments. Each section interlocks using removable connector…
For those situations where cables need protection, but the full-size crossovers are too large, and the extruded rubber type are too small. They are moulded from black polyurethane, and have a…
Extruded rubber sections for use where cables have to be laid across walkways. Bottom wall of extrusion can readily be cut with a sharp knife, to permit protector to be laid over cables; otherwise…
Where cables have to cross carpets and floors temporarily, this tape provides a wonderful alternative to Gaffer tape. Whilst both are quick to install, this is sheer bliss to remove, and Gaffer is…
Black rubber matting, suitable to be laid over a group of cables, where physical protection of the cables is less critical than pedestrian convenience. For example, where cables run across soft…
A multi-purpose anti-vibration non-slip mat. It has a woven texture, and a springy, rubbery feel. It can be used as a low-cost vibration isolating mat, offering a reasonable level of acoustic…
Developed for the offshore oil industry, and used by companies such as Shell, ICI, ARCO, Air Products and Dow Chemicals to help prevent trip hazards and cable damage, these high-quality…
A range of fittings to enable cables to be “flown” or strung overhead between fixed points on buildings, poles etc. Cable flying clamp Similar to B.T. clamp dropwire No.10. Basically a steel wire…
Please select from the list of categories above