A carefully selected range of BNC connectors - adapters, terminators, accessories and tools from leading brands including Telegartner, Canare and Canford.
Designation denotes configuration of adapter contacts, all adapters supplied pre-wired. ‘T’ adapters act as splitters/combiners. Terminology used in adapter…
BNC plugs incorporating a terminating resistor. 50ohm ±1%, 75ohm±1% and “precision” 75ohm ±0.1% suitable for HD-TV. Gold plated centre-contacts, nickel-plated bodies.
All 75 ohm signals, once entered into a termination, must be fully converted into energy. If the impedance matching is not perfect, part of this energy will be reflected and a…
Micro BNC plugs incorporating a precision 75ohm termination, designed for full 1080p applications and general use up to 6GHz. Return loss is -23dB at 6GHz and -26dB at 12GHz and…
Moulded plastic strain reliefs for use with BNC and MUSA crimp connectors. “Groups” refer to Canford Cable Groups, see Coaxial Connectors Selection Guidance entry. All types are…
Silicon rubber strain-relief bushes for Canare BNC, RCA and F connectors. Note that these are not suitable for use with Canare slimline BNC types. CB03 suits Canford Group X size…
Moulded plastic strain reliefs for use with Micro BNC and DIN1.0/2.3 crimp connectors. 'Groups' refer to Canford cable groups (see "Coaxial connector selection guide"). All…
Moulded plastic plates, similar to the Canford 40-991 D-series blanking plate, designed to accept a BNC connector. 13mm hole with anti-rotation flat. They are designed for…
Plastic insulating washers are available for panel mounting of un-insulated type BNC connectors. Washers are supplied singly, two required per connector.
It is often neccessary to fit BNC connectors in drilled, rather than punched, holes, without the anti-rotation flats that a punching tool would provide. Tightening up the locking…
This range of ratchet-action, precision, crimp tools for coaxial connectors are each supplied fitted with the appropriate die-set for Telegartner BNC HD connectors. The tools are…
A range of robust ratchet-action crimp tools each supplied with the appropriate die set specifically designed by Coax Connectors for use with their BNC, Micro BNC and DIN…
A range of crimp tools, and die sets, required to assemble Neutrik Rear Twist and Push-Pull series BNC connectors. Crimp dies are supplied as a pair and must be ordered in…
A Swedish-manufactured crimp tool with scissors ratchet action, emergency release lever, and adjustable crimp force. Die sets are ordered separately as required. These are a…
A range of ratchet-action crimp tools with interchangeable die sets. All tools feature a fully-ratcheting cycle with safety release lever, six ratchet gear settings for adjustable…
A range of tools that are designed to service the various Belden ranges of compression connectors. CPLCCT-SLM Standard compression tool The Belden CPLCCT-SLM compression…
These dust protection covers can be used in Neutrik D-series size panel connectors when no cable connector is mated. The cover is easy to use and does not block the connectors in…
A range of insertion and extraction tools designed by COAX for use with their BNC, Micro BNC and DIN connectors. Note: The BNC insertion and extraction tool is developed for use…
Canford Audio Limited is registered in England and WalesCompany registration no: 1385727VAT no: GB 660116371
